Glass car window is a prayer One Component serves as the Protector And Also as the circulation of air , ON When in the closed car windows will protect you from the Air The Dirty or rain the air while being driving but IF windshield you open it shall cause the circulation of air in hearts your car's cabin.
At least we all know the glass on the car window is always open and the lid if needed , but there are some cases that is where the windshield that uses a system of automatic power window is sometimes the windshield rather difficult time will increase or closed again even could be stuck and not moving at all after the open .
Sometimes a lot of people found in a car power window system is exactly what is broken , but usut calibaration it was not until the cause of the power window glass of the car you're jammed . Apparently the cause on the part of the car glass that expands when exposed to heat could also rubber on the cars windows you had hardened , this is caused by the age factor of the rubber windshield or the weather , especially in Indonesia sometimes hot sometimes wet . Well this is what makes you the rubber windshield hard and cause the glass to your car stalled and less than the maximum current in the cap. but there are some ways to cope with these simple things.
1. Remove Access Panels
First, remove all plastic access panels inside the door and covers which have screw holes in them.
2. Remove Control Switch Panel
The control switch panel ought to be removed employing a flathead screwdriver. The secret usually is to slide the screwdriver underneath the panel and push the panel upwards until it is available off (without breaking ). Its not all cars have switch panels as some cars have their power window controls embedded inside the door panel.
3. Disconnect Electrical Connector
After you‘ve taken the switch panel, disconnect the electrical connector by gently releasing the connector safety.
4. Remove Door Panel
Now, remove all screws and / or door panel bolts upon the door panel. Some bolts will certainly be the push-type and won’t require tools like screwdrivers. In the end the panel bolts are removed, disconnect any remaining electrical connectors and gently achieve the door panel.
5. Remove Plastic Cover
Most cars come having a plastic insulator cover within the door panel. Pull that plastic cover apart and It‘ll expose the inner electrical workings from the door and window.
6. Look through the Window Channel and Take out the Rollers
Look with the window channel, i. e. the area in which the window rolls up and down. You‘ll easily discover the rollers and tracks the window passes through. Remove the rollers which are worn out.
7. Replace the Rollers with New Ones
You will get new rollers for the window from any car spare-parts dealership. Restore the old rollers using the new ones.
8. Lube up the rollers and tracks
It is crucial to sufficiently lubricate the new rollers and tracks to the windows to roll up and down. This also will prevent extra wear and tear sooner or later and can decrease the probability individuals having to repair your power windows again. Use white lithium grease in large amounts.
9. Slide Rollers in Tracks
Slide the rollers straight into the tracks using the fresh lube and obtain the entire structure further smoothed out. But back the regulator, electrical connectors and door panel in reverse order and also your job is performed.
Easy to Fix Electric Power Window With 9 Steps
4/
5
Oleh
Unknown